General

.Combined bending and compression
See the attached article for details about the combined bending and compression check in the tipload modules.
Wed, 27 May, 2020 at 3:55 PM
_Lights and other attachments on poles
Usually lights are ignored but you could create a plant item to model the light. The height and distance would be to the centre of mass of the head. That ...
Thu, 28 May, 2020 at 2:01 AM
_Limitations in the US version
 The US version of the program has some limitations as listed: the tipload module will only correctly calculate the no wind load case.
Thu, 28 May, 2020 at 2:01 AM
.Winds loads on poles and plant
If your power utility does not specify wind loads to use on poles and plant you will need to derive values you feel are suitable for the context.  Wind ...
Thu, 28 May, 2020 at 2:04 AM
.What is the Fixed load?
In the tipload module you can add one or two plant items, and the first item allows you to enter a "Fixed load". This fixed load is not affected b...
Thu, 1 Aug, 2019 at 1:00 PM